Skip to main content

Name tags from a list

In this tutorial you make name tags for a group, for example a class or a workshop, from a list of names. You set up the tag once and KizamuBeam lays out one copy per name.

You need: the list of names, in a spreadsheet or typed in, and a sheet of material for the tags (3 mm plywood or acrylic works well).

1. Start from the template​

  1. Choose File → New from template … and pick Name tag.
  2. The fill-in dialog shows the fields of the template: the name, a Second line, the size and whether the tag gets two holes. Enter a size that suits your material, for example 80 × 30 mm, and confirm.

The template is an ordinary project with parameters. Open Window → Parameters to see them: the text on the tag contains {Name}, which is replaced by the value of the parameter.

You can also design your own tag: draw it, create a text parameter in the Parameters window and type {Name} in a text.

2. Fill in the table​

  1. Choose File → Series from table (CSV) ….
  2. Enter the names, one row per tag. You can paste cells copied from a spreadsheet, or load a file with Import CSV ….
  3. Under Assign columns, choose which column fills which parameter. Columns whose heading matches a parameter name are assigned automatically. Leave the second line on — keep value — if every tag should show the same text.

3. Lay out the series​

  1. Under Layout, choose Grid: as many as fit on the bed, then more pages. Set the spacing between the tags, for example 3 mm.
  2. Click Create series.

KizamuBeam adds the tags on new pages behind the current one, with the names filled in. Your template page stays as it was, and the table is saved with the project, so you can add names later and create the series again.

Long names do not change the size of the tag. Check the pages for names that are too wide for the tag, and shorten them or make the font smaller on the template page before you create the series again.

4. Laser the tags​

  1. Select a page with tags, check the layers (engraving on Fill, the outline on Line) and look at the preview (Alt+P).
  2. Place the material, frame and start. Then go on with the next page.

Variations​

  • Counters and dates: for serial numbers or a date on each job instead of a fixed list, use variable text.
  • Batches of blanks: if you engrave ready-made blanks, cut a jig and use Place on jig slots: variable text counts up per slot.
  • Your own template: File → Save as template … turns your tag into a template that asks for its values, with your own fields and sliders.